Determining Collation Sequence
If you are unsure which carbonless paper collation to use, please, conduct the following test.
Mark two (2) sheets of plain xerographic bond paper Page 1 and Page 2, or 1 and 2.
Load the marked paper sheets into the desired feed tray FACE UP.
Prepare an original for printing. You can use either a 1 or 2-page document. Send the document to the printer. If you use a 1-page document send 2 copies to the printer.
Remove the prints from the output tray without disturbing the sheet sequence.
If the sheet marked "Page 1" is on top then you want to use straight collated carbonless sets.
If the sheet marked "Page 2" is on top then you want to use reverse collated carbonless sets.
If the image has been printed on the blank side of the marked sheets then you must load the carbonless sets into the feed tray FACE DOWN.
TIP: If this procedure indicates that you must load the paper face down you should re-run the procedure (steps 1 7) to verify correct collation.